Display Modes
(ch) The Sunny Remote Control uses four display modes for the display. The Sunny Remote Control will switch to standard mode if the button has not been used for over five minutes.
Standard mode <home>
- Message regarding operation states
- Display of energy flows
- Display of key parameters
In display messages on the Sunny Remote Control, <home> refers to the standard mode.
User mode User
- Display of and access to key operating parameters
In display messages on the Sunny Remote Control, User refers to the user mode.
Installer mode Installer
- Display of and access to configuration and operation parameters
The installer mode is protected with an installer password. In display messages on the Sunny Remote Control, Installer refers to the installer mode.
Expert mode Expert
- Display of and access to all parameters fo the system configuration set in QCG (Quick Configuration Guide)
The expert mode can be accessed only via installer mode (see Operating Manual, section “Installer Mode and Expert Mode”. In display messages on the Sunny Remote Control, Expert refers to the expert mode.
Note:
The parameters for devices that are not configured are hidden, e.g., the generator parameters are hidden for systems without a generator. The parameters for multicluster systems are available only in expert mode.